which an unauthorized switch is added to the network?
Which of these can you implement to prevent future occurrences of this issue?
While troubleshooting a network outage, you discover that an employee brought a switch from
home into the office to connect additional equipment to the network. In order to increase his
speed, he connected this switch to both network ports in his office, resulting in a bridge loop.
Which of these can you implement to prevent future occurrences of this issue?
what will the MPLS experimental bit be set to?
which router should be the first hop to a particular remote destination, allowing simplified client configurat
Which tool allows a LAN client to determine which router should be the first hop to a particular
remote destination, allowing simplified client configuration and processing without creating a single
point of failure?
which of these statements is correct?
When implementing MPLS VPNs between CE and PE routers, which of these statements is
correct?
you need to issue in order to enable syslog messages to be sent to the syslog server at the IP address 10.1.5.
You would like to log messages up to the severity level “Notification.” Which three of these
commands will you need to issue in order to enable syslog messages to be sent to the syslog
server at the IP address 10.1.5.5? (Choose three.)
What is the HSRP state and priority of this interface after HSRP reaches its steady state?
Which of the following may have caused this problem?
While your MPLS core is using Cisco routers, the core of a company you have acquired is not.
After extending your MPLS VPN networks by integrating the cores, you discover that the end-toend LPS path between PE routers cannot be established.
Which of the following may have caused this problem?
which of these may be the reason the packets are being dropped?
You are troubleshooting an issue, which is causing full-sized packets entering the MPLS cloud to
be dropped. You have discovered that one of the switches in the MPLS core is not a Cisco switch,
but otherwise the MPLS MTU size is set to 1508 bytes on the routers. Based on this information,
which of these may be the reason the packets are being dropped?