how many PCI bus addresses will be presented to the server operating system?
An administrator has installed two Cisco VIC adapters. The administrator has also configured four
virtual network interface cards and two virtual host bus adapters. Using this configuration, how
many PCI bus addresses will be presented to the server operating system?
What two Cisco Nexus Fabric Extenders support 10 Gb/s server connectivity?
A network engineer is migrating the server farm from 1 Gb/s Ethernet connectivity to 10 Gb/s
Ethernet connectivity. What two Cisco Nexus Fabric Extenders support 10 Gb/s server connectivity?
(Choose two.)
What changes are observed in traffic flow when the command port-channel load-balance ethernet source-dest-port
An engineer is implementing an FCoE enabled port-channel trunk between two Nexus 5000 series
switches. There are several existing LACP IP only port channels attached to the two Nexus 5000
switches. Traffic monitoring tools show that FCoE storage traffic appears to be pinned to a single
member of the port-channel bundle. What changes are observed in traffic flow when the command
port-channel load-balance ethernet source-dest-port is entered?
Which option achieves this goal?
A network design team is looking for an I/O consolidation technology that uses Cisco Nexus switches
to extend convergence beyond the access layer to a fully converged network. Which option achieves
this goal?
Which three options allow this configuration?
A network engineer wants to configure switch ports on Cisco Nexus 2000 and 2200 Fabric Extender
switches that are connected to a Cisco Nexus 5500 Series Switch. Which three options allow this
configuration? (Choose three.)
When does that occur?
A network engineer wants to enable a FCoE feature on a Cisco Nexus 5500 Series Switch. When does
that occur?
Which three configuration steps are needed for this deployment?
A customer wants to deploy single-hop FCoE in the data center using Cisco Nexus 5500 switches.
Which three configuration steps are needed for this deployment? (Choose three.)
What two conclusions can be made based upon the output?
What is the cause that NP Uplink ports on NPV edge switch are stuck in initializing state?
What two interface types can be used for switch-to-switch communications?
What two interface types can be used for switch-to-switch communications? (Choose two.)