Refer to the exhibit.

A network technician is attempting to use HyperTerminal to configure a new
router using the settings shown. What is the reason the technician is unable to connect to the
router?

Refer to the exhibit.

What could be possible causes for the “Serial0/0 is down” interface status?
(Choose two.)

Which line from the output of the show ip interface command indicates that there is a Layer 1
problem?

Refer to the exhibit.

Workstation A must be able to telnet to switch SW-A through router RTA for
management purposes. What must be configured for this connection to be successful?

Refer to the exhibit. Two buildings on the San Jose campus of a small company must be
connected to use Ethernet with a bandwidth of at least 100 Mbps. The company is concerned
about possible problems from voltage potential differences between the two buildings. Which
media type should be used for the connection?

What are two advantages of Layer 2 Ethernet switches over hubs? (Choose two.)

A PC is attached to the console port of a new Cisco router. The router is powered on. If the PC
has been configured correctly for a console connection, what will the router display after it powers
up?

A Cisco router has received a frame on an interface that is connected to a local network segment.
The router has de-encapsulated the frame. What step is next in processing the packet?

What two actions must a router take in order to route incoming packets? (Choose two.)

A company wants to provide streaming video services to its customers and sales prospects.
Which two characteristics of the network are the most critical to achieving this goal? (Choose two.)