You have been asked to come up with a subnet mask that will allow all three web servers to be on
the same network while providing the maximum number of subnets. Which network address and
subnet mask meet this requirement?

Refer to the exhibit.

Based on the exhibited routing table, how will packets from a host within the 192.168.10.192/26
LAN be forwarded to 192.168.10.1?

How does using the service password-encryption command on a router provide additional
security?

Refer to the exhibit.

How will the router handle a packet destined for 192.0.2.156?

Refer to the exhibit.

The show interfaces serial 0/1 command was issued on the R10-1 router. What can be concluded
from the output in the exhibit?

Refer to the exhibit.

A technician pastes the configurations in the exhibit into the two new routers shown. Otherwise,
the routers are configured with their default configurations. A ping from Host1 to Host2 fails, but
the technician is able to ping the S0/0 interface of R2 from Host1. The configurations of the hosts
have been verified as correct. What could be the cause of the problem?

A router is running three routing processes: RIP, OSPF, and EIGRP, each configured with default
characteristics. Each process learns a route to the same remote network. If there are no static
routes to the destination and none of the routes were redistributed, which route will be placed in
the IP routing table?

A network administrator needs to allow only one Telnet connection to a router. For anyone viewing
the configuration and issuing the show run command, the password for Telnet access should be
encrypted. Which set of commands will accomplish this task?

Refer to the exhibit.

Given the output for this command, if the router ID has not been manually set, what router ID will
OSPF use for this router?

Which command can be used from a router to verify the Layer 3 path to a host?