Refer to the exhibit. What could be possible causes for the “Serial0/0 is down” interface status?
(Choose two.)

Before installing a new, upgraded version of the IOS, what should be checked on the router, and
which command should be used to gather this information? (Choose two.)

Refer to the exhibit. Which two statements are true about interVLAN routing in the topology that is
shown in the exhibit? (Choose two.)

Refer to the exhibit. Which two statements are true about the loopback address that is configured
on RouterB? (Choose two.)

If you are a network administrator, how will you explain VTP configuration to a new technician?
(Choose three.)

Cisco IOS (originally Internetwork Operating System) is the software used on the vast majority of
Cisco Systems routers and all current Cisco network switches. Which two of the following devices
could you configure as a source for the IOS image in the boot system command? (Choose two.)

What are two reasons a network administrator would use CDP? (Choose two.)

Refer to the exhibit. Both switches are using a default configuration. Which two destination
addresses will host 4 use to send data to host 1? (Choose two.)

Exhibit:

Refer to the exhibit. The router has been configured with these commands:

What are the two results of this configuration? (Choose two.)

Your Company has installed IP phones. Both the phones and the office computers connect to the
same device. The phone traffic and the office computer data traffic must be on different networks
to ensure maximum throughput for the phone data. Which network device can be best connected
to the phones and computers, and which technology will be performed on this device? (Choose
two.)