What is the purpose of assigning a default gateway to SW-C switch?
Exhibit:
Refer to the exhibit. CCNA.com has the industrial network shown in the exhibit. All switches are
configured as layer 2 switches and are using VLAN 1 as their management VLAN. Each VLAN 1
interface has been assigned the correct IP address. What is the purpose of assigning a default
gateway to SW-C switch?
Why is SSH preferred over Telnet as a method of accessing a network device to alter or view the configuration?
Why is SSH preferred over Telnet as a method of accessing a network device to alter or view the
configuration?
which loop prevention mechanism provides the fastest reconvergence time after a link failure?
Given a ring topology, which loop prevention mechanism provides the fastest reconvergence time
after a link failure?
Which two ports does EtherNet/IP use to communicate?
Which two ports does EtherNet/IP use to communicate? (Choose two.)
which protocol?
EtherNet/IP is an Ethernet implementation of which protocol?
Which prompt is used to configure parameters for the Ethernet ports of an industrial switch?
Which prompt is used to configure parameters for the Ethernet ports of an industrial switch?
What are the two most relevant factors in determining the class of administration that is required to maintain
What are the two most relevant factors in determining the class of administration that is required to
maintain the telecommunications infrastructure? (Choose two.)
which layer would you perform manufacturing operations and control?
According to the Purdue Reference Model, at which layer would you perform manufacturing
operations and control?
What must be done to accomplish this?
An administrator has connected devices to an industrial switch and, for security reasons, wants
the dynamically learned MAC addresses from the address table added to the running
configuration. What must be done to accomplish this?
What is true about this configuration?
Exhibit:
Refer to the exhibit. C-router is to be used as a “router-on-a-stick” to route between the VLANs. All
the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs
have been configured with the appropriate default gateway. What is true about this configuration?