A service provider creates a network design that runs MPLS in its WAN backbone using OSPF as
the IGP routing protocol. What would be two effects of additionally implementing MPLS-TE?
(Choose two.)

Refer to the exhibit.

Your junior design engineer presents this configuration design. What is the next-hop router for

CE3, and why?

Which two mechanisms ensure that a network design provides fast path failure detection?
(Choose two.)

In which two ways is a network design improved by the inclusion of IP Event Dampening?
(Choose two.)

You are evaluating convergence characteristics of various interior gateway protocols for a new
network design. Which technology allows link-state routing protocols to calculate paths to
destination prefixes that are functionally similar to feasible successors in Enhanced Interior
Gateway Routing Protocol?

You are hired to design a solution that will improve network availability for users on a campus
network with routed access. If the budget limits you to three components, which three components
would you recommend in your design proposal? (Choose three.)

You are designing a network to support data, voice and video. Which two main factors will you
address to improve network convergence? (Choose two.)

Refer to the exhibit.

This diagram depicts the design of a small network that will run EIGRP on R1 and R2, and EIGRP
Stub on R3. In which two ways will this network be impacted if there is link instability between R1
and R2? (Choose two.)

Refer to the exhibit.

In this BGP design, what is the next hop for 10.1.1.0/24 on R8 and R7?

Refer to the exhibit.

You are developing a migration plan to enable IPv6 in your IPv4 network. Starting at R3 and
assuming default IS-IS operations, what is likely to happen when you enable IPv6 routing on the
link from R3 to R2?