While reviewing data gathered during a passive RF site survey for an existing network of Cisco
Aironet 1260 Series Access Points, you discover a high amount of potential co-channel interference
throughout the network. Which two of these are potential causes? (Choose two.)

You are tasked with creating a controller-based high-density RF design. Which three factors
determine the cell size? (Choose three.)

You are tasked with designing a wireless network to support a specific 5-GHz wireless phone. During
the initial design phase you are unable to obtain the client device radio specifications. From a
network configuration perspective, which of these cannot be configured before you obtain the radio
specifications?

You are configuring an autonomous wireless guest network for your customer. The customer
requires that guest users be unable to communicate with one another. Which solution best meets
this requirement?

What is the advantage of EAP-FAST compared to LEAP?

Which of the below statement is correct with regards to configuring local MAC authentication on an
AP?

Which two statements are not correct about client MFP? (Choose two.)

Company XYZ has a wireless network in place. Which three general guidelines should be followed to
overlay a Cisco Context-Aware Mobility Solution? (Choose three.)

You are designing a wireless infrastructure for an enterprise customer in the busy international
banking district of Tokyo. All the client adapters are fairly modern, so you have turned off 802.11b
speeds to reduce the size of your cells. Which channels will you choose to make optimum use of the
available spectrum?

Which three are equivalent forms of the IPv6 address
2011:0000:0000:0000:2010:0000:0000:000F? (Choose three.)