After UDLD is implemented, a Network Administrator noticed that one port stops receiving UDLD packets. This port continues to reestablish until after eight failed
retries. The port then transitions into the errdisable state. Which option describes what causes the port to go into the errdisable state?

RSPAN has been configured on a Cisco Catalyst switch; however, traffic is not being replicated to the remote switch. Which type of misconfiguration is a cause?

Which four LACP components are used to determine which hot-standby links become active after an interface failure within an EtherChannel bundle? (Choose
four.)

Refer to the exhibit.

When troubleshooting a network problem, a network analyzer is connected to Port f0/1 of a LAN switch. Which command can prevent BPDU transmission on this
port?

Your customer has asked you to come in and verify the operation of routers R1 and R2 which are configured to use HSRP. They have questions about how these
two devices will perform in the event of a device failure.

What is the virtual mac-address of HSRP group 1?

Your customer has asked you to come in and verify the operation of routers R1 and R2 which are configured to use HSRP. They have questions about how these
two devices will perform in the event of a device failure.

What issue is causing Router R1 and R2 to both be displayed as the HSRP active router for group 2?

Your customer has asked you to come in and verify the operation of routers R1 and R2 which are configured to use HSRP. They have questions about how these
two devices will perform in the event of a device failure.

Refer to the exhibit. If router R1 interface Etherne0/0 goes down and recovers, which of the statement regarding HSRP priority is true?

Your customer has asked you to come in and verify the operation of routers R1 and R2 which are configured to use HSRP. They have questions about how these
two devices will perform in the event of a device failure.

What percentage of the outgoing traffic from the 172.16.10.0/24 subnet is being forwarded through R1?

Ferris Plastics, Inc. is a medium sized company, with an enterprise network (access, distribution and core switches) that provides LAN connectivity from user PCs
to corporate servers. The distribution switches are configured to use HSRP to provide a high availability solution.
· DSW1 -primary device for VLAN 101 VLAN 102 and VLAN 105
· DW2 – primary device for VLAN 103 and VLAN 104
· A failureof GigabitEthemet1/0/1 on primary device should cause the primary device to release its status as the primary device, unless GigabitEthernet1/0/1 on
backup device has also failed.
Troubleshooting has identified several issues. Currently all interfaces are up. Using the running configurations and show commands, you have been asked to
investigate and respond to the following question.

If GigabitEthemet1/0/1 on DSW2 is shutdown, what will be the resulting priority value of the VLAN 105 HSRP group on router DSW2?

Ferris Plastics, Inc. is a medium sized company, with an enterprise network (access, distribution and core switches) that provides LAN connectivity from user PCs
to corporate servers. The distribution switches are configured to use HSRP to provide a high availability solution.
· DSW1 primary device for VLAN 101 VLAN 102 and VLAN 105
· DSW2 primary device for VLAN 103 and VLAN 104
· A failure of GigabitEthemet1/0/1 on primary device should cause the primary device to release its status as the primary device, unless GigabitEthernet1/0/1 on
backup device has also failed.
Troubleshooting has identified several issues. Currently all interfaces are up. Using the running configurations and show commands, you have been asked to
investigate and respond to the following question.

What is the priority value of the VLAN 105 HSRP group on DSW2?