What is the maximum number of switches that can be stacked using Cisco StackWise?
What is the maximum number of switches that can be stacked using Cisco StackWise?
Which configuration must be added to the new switch before it can be added to the switch stack?
A network engineer wants to add a new switch to an existing switch stack. Which configuration
must be added to the new switch before it can be added to the switch stack?
What percentage of bandwidth is reduced when a stack cable is broken?
What percentage of bandwidth is reduced when a stack cable is broken?
Which set of configurations will result in all ports on both switches successfully bundling into an EtherChann
How can the traffic that is mirrored out the GigabitEthernet0/48 port be limited to only traffic that is recei
Which three items must be configured to mirror traffic to a packet sniffer that is connected to the distributi
Why is the EtherChannel bundle not working?
After an EtherChannel is configured between two Cisco switches, interface port channel 1 is in the
down/down state. Switch A is configured with channel-group 1 mode active, while Switch B is
configured with channel-group 1 mode desirable. Why is the EtherChannel bundle not working?
What should be done on the Cisco switch to allow for better EtherChannel utilization to the corporate web serv
An EtherChannel bundle has been established between a Cisco switch and a corporate web
server. The network administrator noticed that only one of the EtherChannel links is being utilized
to reach the web server. What should be done on the Cisco switch to allow for better
EtherChannel utilization to the corporate web server?
What is the result of the implemented command?
Interface FastEthernet0/1 is configured as a trunk interface that allows all VLANs. This command
is configured globally:
monitor session 2 filter vlan 1 – 8, 39, 52
What is the result of the implemented command?
What would cause the output to show only the single neighbor?
A network engineer notices inconsistent Cisco Discovery Protocol neighbors according to the
diagram that is provided. The engineer notices only a single neighbor that uses Cisco Discovery
Protocol, but it has several routing neighbor relationships. What would cause the output to show
only the single neighbor?