Refer to the exhibit. OSPF has been configured on all routers in the network. However,
router
R1 does not receive a default route to router R2 as intended. Which configuration change
would ensure that R1 would receive a default route from R2?
Select the best response.

Which two statements about the IS-IS routing protocol are true? (Choose two.) Select 2
response(s).

You are a network technician, study the exhibit carefully. All multilayer switches are running
PIM sparse mode. Host CKB and Host CKF are sending IGMPv2 join messages to their
respective multilayer switches. Which description is correct?

A router is running BGP and receives more than one route for a particular prefix. Assume all
the routes for this prefix have the same attributes. Which three path features would be
reasons be for the router to ignore some of the routes and not consider them as candidates
for the best path? (Choose three.)

Refer to the exhibit. EIGRP had converged in AS 1 when the link between router R1 and R2
went down. The console on router R2 generated the following messages: *Mar 20 12:12:06:
%DUAL-5-NBRCHANGE: IP-EIGRP 1: Neighbor 10.1.4.3 (Serial0) is down: stuck in active
*Mar 20 12:15:23: %DUAL-3-SIA: Route 10.1.1.0/24 stuck-in-active state in IP-EIGRP 1.
Cleaning up
The network administrator issued the show ip eigrp topology active command on R2 to
check the status of the EIGRP network. Which statement best describes the reason for the
error messages? Select the best response.

Refer to the exhibit. A network administrator has configured DHCP services on the router as
shown. DHCP clients connected to the FastEthernet0/0 interface are working properly.
DHCP clients connected to the FastEthernet0/1 interface are not receiving addresses. Which
two statements contain recommendations that will solve the problem? (Choose two.)

Which two statements are true about IS-IS routing? (Choose two.)

Refer to the exhibit. Router RTA has been configured as a DHCP server. The two debug
commands will generate output on RTA when Host A requests an IP address. Which set of
DHCPD debug messages is in the correct sequence?

What is the MAC address that comes from the multicast address 239.255.0.1?

Refer to the exhibit. EIGRP has been configured on all routers in the network. The command
metric weights 0 0 1 0 0 has been added to the EIGRP process so that only the delay metric
is used in the path calculations.
Which router will R1 select as the successor and feasible successor for Network A?

Select the best response.