An administrator types in the command router ospf 1 and receives the error message:
“OSPF process 1 cannot start.” (Output is omitted.) What should be done to correctly set up
OSPF?

Refer to the exhibit. Which statement is true about the configuration?

Refer to the exhibit. Which statement is true?

Refer to the exhibit. OSPF has been configured on all routers in the network and Area 1 has
been configured as a NSS

A . Which statement is true about the NSSA Area 1?

According to RFC 2328, what is the stateful order in which an OSPF router transitions to a
full adjacency with a neighbor router?

SIMULATION
OSPF is configured on routers Amani and Lynaic. Amani’s S0/0 interface and Lynaic’s S0/1
interface are in Area 0. Lynaic’s Loopback0 interface is in Area 2.
Your task is to configure the following:
• Portland’s S0/0 interface in Area 1
• Amani’s S0/1 interface in Area 1
• Use the appropriate mask such that ONLY Portland’s S0/0 and Amnani’s S0/1 could
be in Area 1.
Area 1 should not receive any external or inter-area routes (except the default route).

A network administrator has enabled OSPF across an NBMA network and has issued the
command ip ospf network nonbroadcast. Given those facts, which two statements are true?
(Choose two.)

Which of the following is an OSPF configuration parameter that is used on an ABR, but not
on an internal router?

Refer to the exhibit. Which two statements are true about the partial configuration that is
provided? (Choose two.)

Refer to the exhibit. Which two statements are correct? (Choose two.)