Refer to the exhibit. Which three commands should be used on router B1 to redistribute the
EIGRP AS 10 routes into RIP? (Choose three.)

Select 3 response(s).

Refer to the exhibit. Examine the partial configuration and the routing table excerpt. Which
routes would be redistributed into OSPF area 1?

Select the best response.

Refer to the exhibit. Examine the partial configuration and the routing table excerpt. Which
routes would be redistributed into OSPF area 1?

Select the best response.

Refer to the exhibit. A new TAC engineer came to you for advice. A GRE over IPsec tunnel
was configured, but the tunnel is not coming up. What did the TAC engineer configure
incorrectly?

Refer to the exhibit. Currently the two eBGP links between AS100 and AS200 have an
average inbound load of 65% and 20% respectively. After further investigation, traffic to
10.10.1.16/28 accounts for 45%, and traffic to 10.10.1.32/28 and to 10.10.1.48/28 each
account for 20% of the inbound load. The BGP attributes are currently set at their default
values in both autonomous systems.
If you want to influence how AS200 sends traffic to AS100, which eBGP configurations
would you configure in AS100 to influence AS200 to use the eBGP links more evenly?
(Choose two.)

Select 2 response(s).

Which two statements about route redistribution when implementing OSPF are true?
(Choose two.)
Select 2 response(s).

Which two routing interface parameters are supported in OSPF implementations? (Choose
two.)
Select 2 response(s).

Refer to the exhibit. A new TAC engineer comes to you for advice. The engineer wants to
configure RIPv2-OSPF two-way redistribution while avoiding routing loops. Which two
additions to the router B1 configuration should the engineer make? (Choose two.)
Select 2 response(s).

You want the redistributed EIGRP AS 10 routes to have an administrative distance of 121
when they appear as RIP routes in the routing table of A1.
Which command should you use on a router to accomplish this goal? Select the best
response.

Refer to the exhibit. In a redundant hub-and-spoke deployment using EIGRP, what feature
can be used to ensure that routers C through F are not used as transit routers for data
traveling from router B to network 10.1.1.0? Select the best response