A network administrator is trying to add a new router into an established OSPF network. The
networks attached to the new router do not appear in the routing tables of the other OSPF routers.
Given the information in the partial configuration shown below, what configuration error is causing
this problem?
Router(config)# router ospf 1
Router(config-router)# network 10.0.0.0 255.0.0.0 area 0

Which two statements about the OSPF Router ID are true? (Choose two.)

What are two benefits of using a single OSPF area network design? (Choose two.)

When a router undergoes the exchange protocol within OSPF, in what order does it pass through
each state?

What are two enhancements that OSPFv3 supports over OSPFv2? (Choose two.)

What are two enhancements that OSPFv3 supports over OSPFv2? (Choose two.)

What command sequence will configure a router to run OSPF and add network 10.1.1.0 /24 to area
0?

Refer to the exhibit.

If the router Cisco returns the given output and has not had its router ID set manually, what value
will OSPF use as its router ID?

What OSPF command, when configured, will include all interfaces into area 0?

Which statement describes the process ID that is used to run OSPF on a router?