Host 1 is trying to communicate with Host 2. The e0 interface on Router C is down.

Which of the following are true? (Choose two.)

Which commands are required to properly configure a router to run OSPF and to add network
192.168.16.0/24 to OSPF area 0? (Choose two.)

A router receives information about network 192.168.10.0/24 from multiple sources. What will the
router consider the most reliable information about the path to that network?

What is the default maximum number of equal-cost paths that can be placed into the routing table
of a Cisco OSPF router?

Which command shows your active Telnet connections?

Which type of EIGRP route entry describes a feasible successor?

The network administrator cannot connect to Switch1 over a Telnet session, although the hosts
attached to Switch1 can ping the interface Fa0/0 of the router.

Given the information in the graphic and assuming that the router and Switch2 are configured
properly, which of the following commands should be issued on Switch1 to correct this problem?

Refer to the exhibit.

Which of these statements correctly describes the state of the switch once the boot process has
been completed?

Two routers named Atlanta and Brevard are connected via their serial interfaces as illustrated, but
they are unable to communicate. The Atlanta router is known to have the correct configuration.

Given the partial configurations, identify the fault on the Brevard router that is causing the lack of
connectivity.

Users on the 172.17.22.0 network cannot reach the server located on the 172.31.5.0 network. The
network administrator connected to router Coffee via the console port, issued the show ip route
command, and was able to ping the server.

Based on the output of the show ip route command and the topology shown in the graphic, what is
the cause of the failure?