Refer to the exhibit.

The show interfaces serial 0/1 command was issued on the R10-1 router. Based on the output
displayed which statement is correct?

Refer to the exhibit.

RTA is configured with a basic configuration. The link between the two routers is operational and
no routing protocols are configured on either router. The line shown in the exhibit is then added to
router RTA. Should interface Fa0/0 on router RTB shut down, what effect will the shutdown have
on router RTA?

Which three statements are typical characteristics of VLAN arrangements? (Choose three.)

The output of the show frame-relay pvc command shows “PVC STATUS = INACTIVE”. What does
this mean?

Refer to the exhibit.

Hosts in network 192.168.2.0 are unable to reach hosts in network 192.168.3.0. Based on the
output from RouterA, what are two possible reasons for the failure? (Choose two.)

Refer to the exhibit.

The output that is shown is generated at a switch. Which three statements are true? (Choose
three.)

Refer to the exhibit.

When running EIGRP, what is required for RouterA to exchange routing updates with RouterC?

Which term describes a spanning-tree network that has all switch ports in either the blocking or
fowarding state?

What command is used to verify the DLCI destination address in a Frame Relay static
configuration?

Refer to the exhibit.

A technician has configured the FastEthernet 0/1 interface on Sw11 as an access link in VLAN 1.
Based on the output from the show vlan brief command issued on Sw12, what will be the result of
making this change on Sw11?