Which commands are required to properly configure a router to run OSPF and to add network
192.168.16.0/24 to OSPF area 0? (Choose two.)

What is the default maximum number of equal-cost paths that can be placed into the routing table
of a Cisco OSPF router?

A network administrator is trying to add a new router into an established OSPF network. The
networks attached to the new router do not appear in the routing tables of the other OSPF routers.
Given the information in the partial configuration shown below, what configuration error is causing
this problem?
Router(config)# router ospf 1
Router(config-router)# network 10.0.0.0 255.0.0.0 area 0

A network administrator is troubleshooting the OSPF configuration of routers R1 and R2. The
routers cannot establish an adjacency relationship on their common Ethernet link.

The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2.
Based on the information in the graphic, what is the cause of this problem?

Refer to the exhibit.

Assume that all router interfaces are operational and correctly configured. In addition, assume that
OSPF has been correctly configured on router R2. How will the default route configured on R1
affect the operation of R2?

OSPF routing uses the concept of areas. What are the characteristics of OSPF areas? (Choose
Three.)

Refer to the exhibit.

Which two statements are true about the loopback address that is configured on RouterB?
(Choose two.)

Which characteristics are representative of a link-state routing protocol? (Choose three.)

The internetwork infrastructure of company XYZ consists of a single OSPF area as shown in the
graphic. There is concern that a lack of router resources is impeding internetwork performance. As
part of examining the router resources, the OSPF DRs need to be known. All the router OSPF
priorities are at the default and the router IDs are shown with each router.

Which routers are likely to have been elected as DR? (Choose two.)

Refer to the exhibit.

The network is converged.After link-state advertisements are received from Router_A, what
information will Router_E contain in its routing table for the subnets 208.149.23.64 and
208.149.23.96?