Which two commands will display the current IP address and basic Layer 1 and 2 status of an interface?
Which two commands will display the current IP address and basic Layer 1 and 2 status of an
interface? (Choose two.)
What command will allow the administrator to check the changes that have been made prior to saving the new con
An administrator is in the process of changing the configuration of a router.What command
will allow the administrator to check the changes that have been made prior to saving the new
configuration?
which commands will verify the operational status of router interfaces?
On a live network, which commands will verify the operational status of router interfaces?
(Choose two.)
Which router command will configure an interface with the IP address 10.10.80.1/19?
Which router command will configure an interface with the IP address 10.10.80.1/19?
which router prompt will be displayed?
Refer to the exhibit.
If the resume command is entered after the sequence that is shown in the exhibit, which router
prompt will be displayed?
Which default gateway address should be assigned to HostA?
Refer to the exhibit.
Which default gateway address should be assigned to HostA?
What will the router do with this packet?
Refer to the output of the corporate router routing table shown in the graphic.
The corporate router receives an IP packet with a source IP address of 192.168.214.20 and a
destination address of 192.168.22.3.
What will the router do with this packet?
What is the default administrative distance of the OSPF routing protocol?
What is the default administrative distance of the OSPF routing protocol?
which of the following commands could be used in R2?
To allow or prevent load balancing to network 172.16.3.0/24, which of the following commands
could be used in R2? (Choose two.)
what type of messaging, if any,occurs between R3 and R4?
After the network has converged, what type of messaging, if any,occurs between R3 and R4?
