what is the subscriber’s trouble symptom?
The following configuration is from a Cisco DSLAM:interface ATM1/1no ip addressdsl profile basicno atm ilmi-keepaliveatm pvc 2 32 interface ATM0/1 1 32This configuration is from a Cisco 2600 router with an ADSL WIC installed:interface ATM0/0.1 point-to-pointip address 192.168.1.2 255.255.255.0pvc 1/32protocol ip 192.168.1.1 broadcastencapsulation aal5snapThe CPE is connected to DSLAM DSL port 1/1 via a DSL line. The subscriber’s DSL service is not working correctly. Based on the information shown in these two “show run” output messages, what is the subscriber’s trouble symptom?
What is the difference between AAL5 SNAP and AAL5 MUX virtual circuits?
What is the difference between AAL5 SNAP and AAL5 MUX virtual circuits?
what command?
The following message is from a Cisco DSLAM:Status:Bitrates:Interleave Path: downstream: 2048 kb/s, upstream: 256 kb/sFast Path: downstream: 0 kb/s, upstream: 0 kb/sMargin: downstream: 18 dB, upstream: 22 dBAttenuation: downstream: 30 dB, upstream: 20 dBInterleave Delay: downstream: 16000 usecs, upstream: 16000 usecsTransmit Power: downstream: 16.0 dB, upstream: 0.0 dBCheck Bytes (FEC):Interleave Path: downstream: 16, upstream: 16Fast Path:
downstream: 0, upstream 0R-S Codeword Size: downstream: 1, upstream: 8Trellis Coding: Not In UseOverhead Framing: Mode 3Operating Mode: ANSI T1 413 Issue 2Line Type: Interleaved OnlyThis information was presented as a result of what command?
what is true?
The following is an excerpt from a “show run” display in a Cisco DSLAM.interface ATM1/1no ip addressatm clock INTERNALno atm ilmi-keepaliveatm soft-vc 2 32 dest-address 47.0091.8100.0000.0030.949c.0b81.4000.0c80.8000.00 4 100Referring to this output message, what is true?
what type of address is being used is:
The field of an ATM address that states what type of address is being used is:
Which one of the following presented choices is clearly the most appropriate information needed to begin troub
A subscriber complains that his DSL rates are slower than the service he ordered. The customer ordered ADSL at 1 mpbs downstream and 256 kbps upstream, but the maximum bitrate observed during file downloads is never more than 128 kbps downstream. Initial troubleshooting shows that the subscriber’s DSL modem is trained at 1024 kbps downstream and 256 kbps upstream. Which one of the following presented choices is clearly the most appropriate information needed to begin troubleshooting the problem?
What will happen?
A router has the above routes listed in its routing table and receives a packet destined for 172.16.0.45. What will happen?
There is no routing protocol running, but Router B and C have the following static routes configured:Router B:
In this network, Host A is trying to reach Host D. There is no routing protocol running, but Router B and C have the following static routes configured:Router B: ip route 10.1.3.0 255.255.255.0 ethernet 1Router C: ip route 10.1.1.0 255.255.255.0 ethernet 1
Which methods can be used to configure the router for the first time?
A new Cisco router has no configuration defined. Which methods can be used to configure the router for the first time? (multiple answer)
The configuration register does NOT retain settings for:
The configuration register does NOT retain settings for: