The following are wire sizes used in telephone company cables. What will allow the best overall DSL performance?

Which three are major inhibitors of ADSL line quality? (multiple answer)

A subscriber’s DSL service was not working correctly. The subscriber discovered that a DSL microfilter was accidentally installed between the DSL modem and telephone line instead of between the telephone and telephone line. What was the symptom observed by the subscriber?

A DSL line status report shows a high number of corrected and uncorrected errors. The line is configured at 4 milliseconds interleave delay and 4 FEC check-bytes. To reduce the number of uncorrected errors without a detailed analysis of whether the errors are continuous or “bursty”, which of the following should provide improved error correction?

The following are wire sizes used in telephone company cables. Which will allow the greatest “reach” (distance) in DSL service?

A DSL customer has subscribed to a service that provides 2 mbps downstream and 256 kbps upstream. The cable length is 10 kft (3 km). The customer reports that file transfers on the DSL line seem slower than normal in recent days. After reviewing the DSL profile parameters for the DSL port, and the actual status of the line, what is the possible reason why the subscriber’s data rates are slower than usual?DSLAM#show dsl int atm 1/1DMT profile parametersMaximum Bitrates:Interleave Path: downstream: 2048 kb/s, upstream: 256 kb/sFast Path:
downstream: 0 kb/s, upstream: 0 kb/sMinimum Bitrates:Interleave Path: downstream: 0 kb/s, upstream:
0 kb/sFast Path: downstream: 0 kb/s, upstream: 0 kb/sMargin: downstream: 6 dB, upstream: 6 dBInterleaving Delay: downstream: 16000 usecs, upstream: 16000 usecsCheck Bytes (FEC):Interleave Path: downstream: 16, upstream: 16Fast Path: downstream: 0, upstream: 0R-S Codeword Size:
downstream: auto, upstream: autoTrellis Coding: DisabledOverhead Framing: Mode 3Operating Mode:
AutomaticTraining Mode: QuickMinrate blocking: DisabledSNR Monitoring:
DisabledStatus:Bitrates:Interleave Path: downstream: 640 kb/s, upstream: 256 kb/sFast Path:
downstream: 0 kb/s, upstream: 0 kb/sMargin: downstream: 6 dB, upstream: 9 dBAttenuation:
downstream: 45 dB, upstream: 31 dBInterleave Delay: downstream: 16000 usecs, upstream: 16000 usecTransmit Power: downstream: 19.4 dB, upstream: 12.0 dBCheck Bytes (FEC):Interleave Path:
downstream: 16, upstream: 16Fast Path: downstream: 0, upstream: 0R-S Codeword Size: downstream:
1, upstream: 8Trellis Coding: Not In UseOverhead Framing: Mode 3Line Fault: NONEOperating Mode:
ITU G dmt Issue 1Line Type: Interleaved Only

A subscriber’s DSL service is configured as PPPoA. The subscriber’s DSL modem is trained, but the subscriber can not access the internet (can not ping network addresses or reach web servers). Initial troubleshooting shows that a PPP session is open (active) in the DSL modem and aggregator. Based on these conditions and the symptom, what is a possible cause of this problem?

What will significantly degrade DSL performance, regardless of DSL rate or line length?

Which of the following CGMP (Cisco Group Management Protocol) statements is correct? (multiple answer)

What is RPF?