what is true?
The following is an excerpt from a “show run” display in a Cisco DSLAM.interface ATM1/1no ip addressatm clock INTERNALno atm ilmi-keepaliveatm soft-vc 2 32 dest-address 47.0091.8100.0000.0030.949c.0b81.4000.0c80.8000.00 4 100Referring to this output message, what is true?
The ATM Transmission Convergence Sublayer is NOT responsible for:
The ATM Transmission Convergence Sublayer is NOT responsible for:
What will the encapsulation type for the PVCs be?
The following configuration is entered on an ATM interface:interface atm 0/0/0encapsulation aal5mux ppp virtual-template 1interface atm 0/0/0.10 multipointpvc 0/100exitpvc 0/101encapsulation aal5snapWhat will the encapsulation type for the PVCs be?
What VCI value is reserved for PNNI ATM routing?
What VCI value is reserved for PNNI ATM routing?
What is the use of a VC class in IOS configuration?
What is the use of a VC class in IOS configuration?
What ATM Adaptation Layer is used when an ATM cell carries IP packets and PPP frames?
ATM carries IP and PPP information within ATM cells. What ATM Adaptation Layer is used when an ATM cell carries IP packets and PPP frames?
What is the function of NSP Cross-Connections in the usage of a 6400 in a production network. (multiple answer
What is the function of NSP Cross-Connections in the usage of a 6400 in a production network. (multiple answer)
what type of address is being used is:
The field of an ATM address that states what type of address is being used is:
What mechanism should be employed to limit the “transmit rate” from Router A to Router C?
What mechanism should be employed to limit the “transmit rate” from Router A to Router C?
What Frame Relay Traffic Shaping map-class sub-command should be entered on Router A to prevent workstation A
Router A has a 512K-access port into the frame relay cloud. Router B has 128K-access port into the frame relay cloud. The two routers are connected with symmetrical PVCs that are configured for 64K committed information rate (CIR). What Frame Relay Traffic Shaping map-class sub-command should be entered on Router A to prevent workstation A from overrunning the access port on Router B?
