Virtual path identifier (VPI) and virtual channel identifier (VCI) values on the NRP-2 must share ___bits. By default, VPI values are limited to ___ bits (0-15), and VCI values are limited to ___ bits (0-1023). A Network Administrator can change the VPI and VCI ranges, but together the VPI and VCI values cannot exceed ___ bits. Which numbers below, correctly fill in the blanks?

What statement regarding Service Selection Gateway is INCORRECT?

What does the Service Selection Gateway (SSG) feature on the NRP support to authenticate and authorize users?

When a subscriber is configured for PPPoE service, the DSL modem is usually configured as:

Inferface FastEthernet 0/0/0ip address 192.168.1.1 255.255.255.0!interface ATM 0/0/0.30 multipointpvc 1/43encapsulation aal5ciscoppp Virtual-Template 2!!interface Virtual-Template 2ip unnumbered FastEthernet 0/0/0no peer default ip addressppp authentication pap chapppp ipcp mask 255.255.255.224!Refer to the configuration above. A customer connected to PVC 1/43 boots their CPE (PPPoA encapsulation). The Radius server is properly configured and recognizes the customer. The Radius server assigns the Framed-IP-netmask 192.168.10.1/29. What information does the CPE receive from the NRP via PPP IPCP negotiation?

What is the purpose of the following command? virtual-template {template-number}pre-clone {number}

A Network Administrator is unable to configure a PVC with the value of 8/49. He looks at the running config and notices the following entry for the interface he is working with. What is the likely cause of the problem?interface ATM0/0/0no ip addressatm vc-per-vp 2048no atm ilmi-keepalive

Routers running OSPF and sharing a common segment become neighbors on that segment. What statement regarding OSPF neighbors is FALSE?

What is the best definition of the use of “Area 0” in OSPF?

Based on the information above, which OSPF configurations listed are valid? (multiple answer)