Refer to the exhibit. What type of issue does this error log indicate if the IP address in the error log is located off of the Router A WAN?

You have two EBGP peers connected via two parallel serial lines. What should you do to be able to load-balance between two EBGP speakers over the parallel serial lines in both directions? (Exhibit)

Refer to the exhibit. You would like to guarantee 7 Mb/s for FTP traffic in your LAN, as it seems that peer-to-peer traffic is taking up a large amount of bandwidth. When testing the configuration, you notice that FTP traffic doesn’t reach 7 Mb/s. What is the problem?

Refer to the exhibit. You have noticed that several users in the network are consuming a great deal of bandwidth for the peer-to-peer application Kazaa2. You would like to limit this traffic, and at the same time provide a guaranteed 100 kb/s bandwidth for one of your servers. After applying the configuration in the exhibit, you notice no change in the bandwidth utilization on the serial link; it is still heavily oversubscribing the interface.
What is the cause of this problem?

Refer to the exhibit. As a network administrator, you have configured a dual-rate, dual-bucket policer in accordance with RFC 2698 on the serial interface of you router, connecting to your provider. The SLA with your provider states that you should only send AF31 (limited to 150 kb/s), AF32 (limited to 50 kb/s)and AF33 (best effort). Your service provider claims you are not conforming to the SLA.
Which two things are wrong with this configuration? (Choose two.)

Refer to the exhibit. When applying this policy map on the tunnel1 interface, you see packet loss for the TCP class starting at around 100000 b/s, instead of the configured 150000 b/s.
What is the most likely cause of the discrepancy?

Refer to the exhibit. When applying this hierarchical policy map on the on the tunnel1 interface, you measure high jitter for traffic going through class 1234. What is the most likely cause of this jitter?

Refer to the exhibit. Which of these is applied to the Bearer class?

Refer to the exhibit. Voice traffic is marked "precedence 5." How much bandwidth is allocated for voice traffic during periods of congestion?

Refer to the exhibit. In the diagram, the switches are running IEEE 802.1w RSPT. On which ports should root guard be enabled in order to facilitate deterministic root bridge election under normal and failure scenarios?