Which of these statements is true about a VSS?
You are about to migrate a customer network to use a VSS. Which of these statements is true about a VSS?
Which OSPF LSA type does an ASBR use to originate a default route into an area?
Which OSPF LSA type does an ASBR use to originate a default route into an area?
Which one of these statements is true of OSPF type 5 LSAs?
Which one of these statements is true of OSPF type 5 LSAs?
What should you do to be able to load-balance between two EBGP speakers over the parallel serial lines in both
You have two EBGP peers connected via two parallel serial lines. What should you do to be able to load-balance between two EBGP speakers over the parallel serial lines in both directions?
which sequence of variables to determine the best received BPDU?
The classic Spanning Tree Protocol (802.1D 1998) uses which sequence of variables to determine the best received BPDU?
Which of these best describes the actions taken when a VTP message is received on a switch configured with the
Which of these best describes the actions taken when a VTP message is received on a switch configured with the VTP mode "transparent"?
which state?
If a port configured with STP loop guard stops receiving BPDUs, the port will be put into which state?
What is a good first test to see if BGP will work across the firewall?
Two routers configured to run BGP have been connected to a firewall, one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer, including the correct BGP session endpoint addresses and the correct BGP session hop-count limit (EBGP multihop). What is a good first test to see if BGP will work across the firewall?
Which improvements does IGMPv3 offer over IGMPv2?
IGMP has versions IGMP vl, v2 and v3. Which improvements does IGMPv3 offer over IGMPv2?
Which statements are true about the following policy map?
There is some confusion on this sim and what it is. So I will tell you that it is a window with 4 squares on the left side. Click each one to see the question. Again, there are 4 questions and one topology. Click the topology button at the bottom of the sim to see it. There is only one topology for all 4 questions. You do NOT log into any routers. All configuration is provided as text in the question.
NOTE: The actual topology may vary with the routing protocol questions selected for the sim and the number of routers could be as high as R6
Which statements are true about the following policy map?
R1#show service-policy Gig1/0
Class Somename1 Match-All
ip dscp 40
match packets size 200 min 1000 max
NO match packets size min 500 max 500
Set IP Prec 2
Class Somename1 Match-All
match packets size 500 min 500 max
Set IP Prec 1
Class default match any