You are configuring a PPP connection between two routers, R1 and R2. The password for the connection will
be poppycock. When you are finished you execute the show run command on R1 to verify the configuration.
Which of the following examples of partial output of the show run command from R1 represents a correct
configuration of PPP on R1?

Which Cisco Internetwork Operating System (IOS) command is used to view the number of Enhanced Interior
Gateway Routing Protocol (EIGRP) packets that are sent and received?

You are a network administrator for your organization. Your organization has two Virtual LANs, named
Marketing and Production. All Cisco 2950 switches in the network have both VLANs configured on them.
Switches A, C, F, and G have user machines connected for both VLANs, whereas switches B, D, and E have
user machines connected for the Production VLAN only. (Click the Exhibit(s) button to view the network
diagram.)
You receive a request to configure Fast Ethernet port 0/2 on Switch B for a user computer in the Marketing
VLAN. VLAN numbers for the Marketing and Production VLANs are 15 and 20, respectively.
Which Cisco 2950 switch command should you use to configure the port?

What two devices can be connected to a router WAN serial interface that can provide clocking? (Choose two.)

You are connecting a new computer to Switch55. The new computer should be placed in the Accounting VLAN.
You execute the show vlan command and get the following output:

Examine the additional network diagram.

What action should you take to place the new computer in the Accounting VLAN and allow for inter-VLAN
routing?

When packets are transmitted from one host to another across a routed segment, which two addresses are
changed? (Choose two.)

What command should you use to quickly view the HSRP state of the switch for all HSRP groups of which the
switch is a member?

You are creating a configuration to use on a switch. The configuration must enable you to remotely manage theswitch.
Which of the following command sets is correct? (Assume the commands are executed at the correct prompt.)

Which of the following techniques is NOT used by distance vector protocols to stop routing loops in a network?

You are discovering that there are differences between the configuration of EIGRP for IPv6 and EIGRP for
IPv4. Which statement is true with regard to the difference?