What command provides the output shown below? A. switch# show vrrp brief B. switch# show standby C. switch# show glbp D. switch# show vrrp Explanation: The command that displays the output in the exhibit is show vrrp. This command displays detailed information regarding VRRP groups on the switch. The information provided for each VRRP group […]

Which of the following sets of commands CANNOT be included in the plan to implement HSRP on a Layer 3 switch port? A. interface port-channelno switchport B. interface fastethernetno switchportip address C. interface fastethernetswitchport mode access D. interface vlanip address Explanation: The following set of commands cannot be included in the implementation plan to configure […]

Which of the following statements are TRUE about the selection of the active router in an HSRP group? (Choose two.) A. The router with the highest priority becomes the active router. B. The router with the lowest priority becomes the active router. C. The router with the highest IP address becomes the active router if […]

A company has the following network infrastructure. (Refer to the exhibit.) Router A is a GLBP active virtual gateway with priority level set to 250. Routers B and C are configured with the default GLPB configurations. The configuration of the active virtual gateway needs to be changed such that if the AVG fails, Router C […]

Which statement best describes the interaction between a workstation and an HSRP virtual router? A. The workstation must have the real IP address of one of the HSRP routers defined as its default gateway. B. The workstation must support IRDP in order to switch to the alternate router in an HSRP group. C. The active […]

When executed on a HSRP group member named Router 10, what effect does the following command have? Router10(config-if)# standby 1 track serial0 25 A. It will cause the router to increase its HSRP priority by 25 if the Serial0 interface on the standby router goes down B. It will cause the router to shut down […]

Which next-hop router redundancy protocol provides backup for an assigned real IP address? A. HSRP B. GLBP C. VRRP D. CGMP Explanation: Using VRRP, the shared address of the next-hop router redundancy group can be the real address of a router interface. Virtual Router Redundancy Protocol (VRRP) is defined in RFC 2338. VRRP enables a […]

What command displays detailed information about the GLBP groups to which the switch belongs? A. switch# show standby B. switch# show glbp state C. switch# show glbp D. switch# show standby detail Explanation: The command show glbp displays detailed information about GLBP groups on the switch. This information includes the GLBP groups the switch is […]

What command can be used on a Cisco switch to display the virtual MAC address for the HSRP groups of which the switch is a member? A. switch# show standby mac B. switch# show hsrp mac C. switch# show standby D. switch# show standby brief Explanation: The command show standby can be used to display […]

Your network consists of one HSRP group of six routers. All of the routers are functioning properly. The network has been stable for several days. In which HSRP state are most of the routers? A. Learn B. Listen C. Standby D. Active Explanation: If all of the routers in the Hot Standby Routing Protocol (HSRP) […]