Where can an administrator specify the notification action to be taken by the firewall in the event that avail
Where can an administrator specify the notification action to be taken by the firewall in the event
that available disk space drops below 15%?
Where can an administrator configure the notification action in the event of a policy install time change?
Where can an administrator configure the notification action in the event of a policy install time
change?
Where are custom queries stored in R77 SmartView Tracker?
Where are custom queries stored in R77 SmartView Tracker?
How do you view a Security Administrator’s activities with SmartConsole?
How do you view a Security Administrator’s activities with SmartConsole?
Which SmartView Tracker selection would most effectively show who installed a Security Policy blocking all tra
Which SmartView Tracker selection would most effectively show who installed a Security Policy
blocking all traffic from the corporate network?
How do you view Security Administrator activity?
You are reviewing the Security Administrator activity for a bank and comparing it to the change
log. How do you view Security Administrator activity?
Which of the following R77 SmartView Tracker views will display a popup warning about performance implications
Which of the following R77 SmartView Tracker views will display a popup warning about
performance implications on the Security Gateway?
What is the correct order of steps needed to set up the block?
While in SmartView Tracker, Brady has noticed some very odd network traffic that he thinks could
be an intrusion. He decides to block the traffic for 60 minutes, but cannot remember all the steps.
What is the correct order of steps needed to set up the block?
1) Select Active Mode tab in SmartView Tracker.
2) Select Tools > Block Intruder.
3) Select Log Viewing tab in SmartView Tracker.
4) Set Blocking Timeout value to 60 minutes.
5) Highlight connection that should be blocked.
SmartView Tracker R77 consists of three different modes.
SmartView Tracker R77 consists of three different modes. They are:
Which column do you check to view the new source IP?
You are troubleshooting NAT entries in SmartView Tracker. Which column do you check to view
the new source IP?
Exhibit: