Which is NOT a solution?
After a sudden spike in traffic, you receive this system log file message: "Kernel: FW-1:
Log Buffer is full". Which is NOT a solution?
which single vpn debug command would you use?
To start both vpnd.elg and ike.elg, which single vpn debug command would you use?
VPN debugging information is written to which of the following files?
VPN debugging information is written to which of the following files?
What is the most likely cause of and solution to this problem?
Gill Bates is in charge of a large enterprise, which requires VPN connections between offices around the world. To achieve this Gill decides to use a dynamic routing protocol to make sure all offices are connected through the VPN community using tunnel interfaces among all peers. Nothing is configured in vpn_route.conf. However, Gill is experiencing connectivity problems and when examining the logs he discovers multiple "out of state" drops. What is the most likely cause of and solution to this problem?
What happens if the buffer becomes full?
fw monitor packets are collected from the kernel in a buffer. What happens if the buffer becomes full?
A SecureRemote/SecureClient tunnel test uses which port?
A SecureRemote/SecureClient tunnel test uses which port?
If an external host port scans the web server’s IP address, what information will be revealed?
Assume you have a rule allowing HTTP traffic, on port 80, to a specific web server in a Demilitarized Zone (DMZ). If an external host port scans the web server’s IP address, what information will be revealed?
Policy Server login and Desktop Policy installation will kill which of the following processes on the client m
Policy Server login and Desktop Policy installation will kill which of the following processes on the client machine?
what vale should stored in the resulting file?
When you verify IP Forwarding on SecurePlatform Pro using the command more /proc/sys/net/ipv4/ip_forward, what vale should stored in the resulting file?
If you save the fw monitor output with option, how do you view the output file afterwards?
If you save the fw monitor output with option, how do you view the output file afterwards?