You have setup the port-channel on your Brocade VDX 6730 running in standalone mode. The
other side of the port-channel is a non-Brocade networking switch that supports 802.3ad. The
configuration has been reviewed and the port-channel is configured correctly on both the
Brocade VDX and the non-Brocade switch. After performing an in-line trace, it was determined
that the Brocade VDX is not transmitting traffic. What is causing this problem?

You install a new 10 Gbps Twinax cable. The port comes online but immediately goes offline.
How would you determine the cause of this problem?

Given the MAC table shown in the exhibit,
***Missing Exhibit***
what happens when an Ethernet Fabric receives a frame with MAC SA 0005.3326.4431 and MAC
DA 0005.3326.7556 on port 1/0/3 VLAN 10?

An application owner whose database is using iSCSI storage has notified you that they are
experiencing frame loss.
***Missing Exhibit***

Based on the CLI output in the exhibit, what is the cause of this problem?

You have added a new Brocade VDX 6730 to your existing Brocade VCS Fabric. You notice that
the new switch has failed to join the fabric.

Based on the CLI output in the exhibit, what are two causes of the problem? (Choose two.)

What is the result of a multicast group with zero receivers?

When an end-station connected to a multi-switch Brocade VCS Fabric tries to reach an unknown
address. Which two statements are true? (Choose two.)

Which two statements about Enhanced Transmission Selection in a Brocade VCS Fabric are true?
(Choose two.)

Values are defined in the default DCB Priority Group Table on a Brocade VDX switch.
Which two statements are true? (Choose two.)

DCBX is used to set which two link peer configurations? (Choose two.)