Which two steps must be taken to ensure proper EBGP peering?
You have been asked to configure a new EBGP connection to your service provider by peering
using your loopback address. Which two steps must be taken to ensure proper EBGP peering?
(Choose two.)
Which port will be placed in a blocked state?
What should you do next to initiate the auto-leveling process?
You are performing a software upgrade on a Brocade VDX 8770 and the firmware download
command has failed while upgrading an interface module. What should you do next to initiate the
auto-leveling process?
What are two considerations when developing this migration plan?
A customer is migrating their FICON servers and storage from an M-Series SAN that is end of
lease to a new SAN using two Brocade DCX 8510-8 Backbones with optical ICLs. They also want
to intermix the FICON and zLinux traffic on the same DCX 8510-8 Backbone. What are two
considerations when developing this migration plan? (Choose two.)
What will allow configuration management on the Brocade VDX platform?
Your network design calls for the management of all switches in-band.
What will allow configuration management on the Brocade VDX platform?
What must you do to ensure the Brocade Network Advisor operates correctly?
You are planning to install Brocade Network Advisor Server in your corporate intranet to manage a
medium-size fabric. You are also installing the client on your desk system. It is a highly secure
installation. You have selected a server with dual processors and a 2.8 GHz clock rate with 8 GBs
of RAM and a 100 GB disk.
What must you do to ensure the Brocade Network Advisor operates correctly?
Which route for network 150.10.1.0/24 will be installed in the IP routing table?
Which statement is true regarding DNS replies sent by the Brocade ADX to clients?
Given the commands shown below:
gslb policy
dns active-only
dns cache-proxy
Which statement is true regarding DNS replies sent by the Brocade ADX to clients?
What happens to Ethernet frames that enter a switch with MAC learning disabled on all interfaces?
What happens to Ethernet frames that enter a switch with MAC learning disabled on all interfaces?
Which configuration change will minimize the traffic loss?
A customer has configured a two-port vLAG from two Brocade VDX 8770-4s which are members
of a VCS fabric to a VDX 6720 in stand-alone mode. On both switches, the port-channel and
VLANs are configured as shown in the exhibit. When a failed link of the vLAG is restored, the
traffic between the two servers fails for 10 seconds before the traffic is restored.
Which configuration change will minimize the traffic loss?