Which command saves the running configuration of anHP E5400 zl Series switch to its startup configuration?

Refer to the Exhibit.

To begin updating the software on this HP E-Series switch, an administrator issues the following command at
the CLI: Switch(config)# copy usb flash K_14_65.swisecondary If the file transfer is successful, whenwill the
switch begin using the K.14.65 software?

What is the effect of the following command issued at the CLI of an HP E5400 zl Series switch? Switch#show
logging 1

What is the relationship between the primary and secondary flash areas of an HP E8206 zl switch?

What is a Virtual Service Community (VSC)?

Which 802.11n frequency ranges are supported on theE-MSM422 Access Point? (Select two.)

You must configure an E-MSM Access Point that is configured for autonomous mode. Which management
interface must you use for this task?

You must install an HP E-MSM AP that is at factory settings. When must you change the AP’s operating
mode?

You must connect an E-MSM Access Point to a switch that supports the PoE (802.3af) standard. What is the
maximum amount of power the AP will be able to receive from the switch?

What is the VLAN membership of wireless traffic exiting the bridge port on an HP E-MSM Access Point with
default VLAN settings?