A network administrator has installed an HP MSM765 zl controller in slot D of an HP 8212 zl
switch. The administrator plans to configure a management IP address on the controller’s
(untagged) internet port network and have APs communicate with the controller on that address.
This solution is in the subnet that is associated with VLAN2 in the corporate LAN.
How should the administrator configure the internet port network to connect in the correct VLAN?
A.
On the switch, specify VLAN2 as the untagged VLAN on interface d1
B.
On the switch, specify VLAN 2 as the tagged VLAN on interface d1
C.
On the controller, configure the VLAN ID in the internet port network’s mapping internet port.
D.
On the controller, configure the VLAN ID in the internet port network profile
Explanation:
Student Guide Book 1 – Implementing and Troubleshooting HP Wireless Networks – Page 2-5
The HP zl switch also has two ports in the line card that are hard cabled to themodule ports. The
switch CLI refers to the ports as <slot>1 and <slot>2, <slot> beingthe letter of the slot in which the
MSM765 zl is installed. The <slot>1 port connectsto the Internet port, and the <slot>2 port
connects to the LAN port. You treat theseports as you do other ports on the switch. You can
enable, disable, and assignVLANs to them. For example, an MSM765 zl switch is installed in slot
D of an HP8212 zl switch, and you want to connect the MSM765 zl’s untagged Internet
portnetwork in VLAN 11. You would enter this command in the switch CLI:
Switch(config)# vlan 11 untagged d1