Refer to the exhibit An administrator is planning an MPLS solution and wants to make sure
that traffic from 10.1.0.0716 to 10.2 0.0/16 takes the best path. The solution is not using
Traffic Engineering (TE). How does PE-1 choose between the label advertised for
10.2.0.0/16 by P-4 and by P-5?

Why might a customer decide to use MDC instead of Multi-VPN-Instance CE (MCE)?

Refer to the exhibit An administrator is configuring an MPLS VPLS Martini solution on PE-1.
The VPLS solution should connect customer A sites 1, 2, and 3 Where should the
administrator specify the LDP peers and pseudo wire (PW) label for the PWs?

An administrator configures an HP Comware switch to support FCoE in Fibre Channel
Forwarder (FCF) mode A switch interface connects to a server FC host bus adapter (HBA)
What is the correct configuration for this port?

What must be used when implementing the backbone multicast feature to isolate multicasts
in the SPBM region?

Refer to the exhibit An EVI network is being set up as shown in Exhibit 1. Part of Switch 1’s
configuration is shown in Exhibit 2 All other switches are configured correctly and can reach
each other. The EVI links should carry traffic in VLANs 4 to 20; however, when the
administrator tries to ping a VLAN 4 device in DC 2 from DC 1. the ping fails. What should
the administrator do?

Which statement is correct about a Fibre Channel (FC) node-port (N-port) in a Storage Area
Network (SAN) fabric topology?

An HP Comware switch supports FCoE in Fibre Channel Forwarder (FCF) mode. A switch
interface Ten1/0/1 connects to a server FCoE Converged Network Adapter (CNA). The
CNA transmits normal data traffic, which is tagged for VLANs 4 and 8. and storage traffic for
VSAN 2, which is associated with VLAN 20. What is a correct port type and VLAN
configuration for Ten 1/0/1?

Refer to the exhibit An administrator is creating the EVI network shown in the exhibit
Switches 1 and 2 are configured as ENDP servers. and Switch 3 is configured as an ENDP
client to the ENDP servers. Which configuration is correct for the EVI tunnel interface on
Switch 3?

An administrator is implementing MDC and wants to create a redundant solution where
each MDC uses two physical HP Comware switches What is the correct setup process?