HP has released a new version of an access controller software package file. How does the
network administrator activate the new software version?

It is Monday morning, and no one can connect to the wireless network. The network
administrator suspects that the access controller’s certificate may have expired and is no
longer valid. How can the administrator check if this is the problem?

Which command configures the management IP address on a WLAN controller?

An administrator wants to configure authentication on the HP 830 switch ports that connect
to wireless access points. The company policy requires all wireless users to be
authenticated using 802.1X authentication. Each port should also allow multiple wireless
users to pass 802.1X authentication. Which port security mode meets these requirements?

Refer to the exhibit.

An engineer is installing a new access point (AP). The AP has successfully acquired an IP
address. The engineer can ping the access controller (AC) from the AP. However the AC is
not discovering the AP. What could cause this problem?

Refer to the exhibit.

The access controller (AC) has configured session-mode load balancing. The maximum
number of sessions is configured as 5. The maximum session gap is configured as 4. Client
1 is associated with API Clients 2 to 6 are associated with AP2. Client 7 can only hear AP2.
Client 7 attempts to associate to AP2. What happens?

Which factors impact the calculation of the Effective Isotropic Radiated Power (EIRP)?

Refer to the exhibit.

What does the Auth Mode enable?

Refer to the exhibit.

What is the primary advantage of enabling SSID Hide?

To allow user access for corporate employees, a network administrator sets an SSID named
CORPORATE using an HP Unified Wireless solution. The administrator wants these security enhancements:
+Enable 802.1x authentication in PEAP MS-CHAP V2 mode on this SSID along with AES and WPA2.
+Set the User Access Manager server at 10.0.1.100 to authenticate 802.1x supplicants. The
network administrator enters these commands:

What is another set of commands that must be entered onto the Unified Wireless Controller
in system-view mode to define the SSID CORPORATE with 802.1X Authentication in PEAP
MSCHAPV2, using the defined RADIUS server?