Refer to the network exhibit.

All of the switches in the exhibit are configured as follows:
• Config name = “Region!’
• Revision #= 1
• Instance 1=VLANs 10.12
• lnstance2 = VLANs11,13
• 1ST instance = VLANs 1-9.14-4094
Currently, onlyVLANs 1,10,11,12, and 13 exist on the four switches. A network administrator adds
VLAN 15 to Switch_C. How is the topology affected by this change?

Refer to the network exhibit.

A network administrator has created a Layer 2 network based on the design shown in the exhibit.
Switch-A and Switch-B are distribution layer switches. Switch-C is an access layer switch. All
switches are HP Comware switches.
What is the best spanning tree solution for load sharing on uplinks in this environment?

Which 802.1X component seeks authentication?

Which management protocol is enabled, by default, on HP Provision switches?

Which HP Comware command saves the startup configuration file to a TFTP server?

Refer to the exhibit.

A network administrator has a server currently connected to an access layer switch. The network
administrator needs link redundancy for the server and wants to add a second access layer switch
and connect it to the server. Which solution should the network administrator implement to
accomplish this goal?

Which HP redundancy feature is supported by both HP Provision and HP Comware switches?

Refer to the exhibit.

The link aggregation is failing between the HP Provision and HP Comware switches. Which
solution solves this problem?

Which Intelligent Management Center (IMC) device discovery method is the default for device auto
discovery?

Which HP Comware command can a network administrator execute to view the IP routing table?