An HP A-Series switch includes the following configuration:

Which VLANs are in instance 0?

You have successfully installed an HP PCM+ remote client on a network administrator’s workstation. Which
step is necessary to enable the client to
access the PCM+ server ?

You must configure VLANs and ports on an HP A7500 switch at default settings. What is the effect of the
following commands?
[SW-Gigabit-Ethernet1/0/1]port link-type trunk
[SW-Gigabit-Ethernet1/0/1]port trunk permit vlan 100 101

You must connect an E-MSM Access Point to a switch that supports the PoE+ (802.3at) standard. What is the
maximum amount of power the AP will be able to receive from the switch?

Refer to the Exhibit.

What does the output shown in the exhibit indicate about this HP E3500-24G yl switch? (All switches inthe
Spanning Tree are at default settings.)

You must configure static link aggregation using LACP between an HP E5406 zl switch and an HP E8212 zl
switch. What must match on all ports that will
be included in the aggregated link? (Select three.)

What is an advantage of using a ring topology when designing an IRF stack using A-Series switches?

You enter the following command at the CLI of an HPE5412 zl Series switch:Switch(config)# spanning-tree
priority 3Which Bridge Priority value is
displayed when you enter show spanning-tree?

You must define a hostname on an HP E5400 zl Seriesswitch. Which configuration context must you enterto
perform this task?

By default, which criteria are used for load-sharing of Layer 3 traffic over aggregated links configured on HP A-Series switches?