Port B24 on an HP E5400 zl Series switch is a tagged member of VLAN 101. Ports B21, B22, and
B23 are at default settings. What is the result of the following command?
Switch(config)# trunk B21-B24 trk1

In HP PCM+, which privilege is only available to users with the Administrator profile?

You must install an HP E-MSM AP that is at factory settings. When must you change the AP’s
operating mode?

What is the relationship between the primary and secondary flash areas of an HP E8206 zl
switch?

What is the effect of the following command issued at the CLI of an HP E5400 zl Series switch?
Switch# show logging 1

Refer to the Exhibit.

To begin updating the software on this HP E-Series switch, an administrator issues the following
command at the CLI: Switch(config)# copy usb flash K_14_65.swi secondary If the file transfer is
successful, when will the switch begin using the K.14.65 software?

Which command saves the running configuration of an HP E5400 zl Series switch to its startup
configuration?

What is the VLAN membership of wireless traffic exiting the bridge port on an HP E-MSM Access
Point with default VLAN settings?

You must configure an E-MSM Access Point that is configured for autonomous mode. Which
management interface must you use for this task?

Which 802.11n frequency ranges are supported on the E-MSM422 Access Point? (Select two.)