A network administrator enables OSPF on an HP Provision ASIC switch and creates area 0 and area 1.
The network administrator then enters this command:
Switch(ospf)# area 1 range 10.1.0.0/16
After other switches are configured and establish adjacencies, how will this command affect the final behavior
of the switch?

What is the first step a network administrator should complete to configure the first remote mirroringsession
between an HP 5400 zl and an HP 8200 zl switch?

Which statement accurately describes how network administrators can apply routed access control lists
(RACLs) or VU\N access control lists (VACLs) on an HP 8200 zl switch?

A network administrator wants to configure the precise MAC addresses that are allowed to send traffic on a
particular port on an HP 5400 zl Series switch. No other addresses can send traffic. Which task shouldthe
administrator complete?

Two HP Provision switches are configured as virtualrouters. How does the VRRP backup know if the VRRP
master is available and functioning?

View the exhibit.

An IRF device consists of four HP 5820 switches. The IRF topology is shown in Exhibit 1. The IRF settings are
shown in Exhibit 2. After these settings are displayed, Member 2 experiences a power failure and shutsdown.
After an hour, power is restored, and Member 2 reboots. Based on this event and the exhibits, what happens
next?

View the exhibit.

In the example network shown in the exhibit, switchA loses power and becomes unavailable. Which switch
ports have the designated role in instance 1 when the MSTP network converges again?

View the exhibit.

Area 1 and Area 2 in the topology are associated with/21 subnets, shown in Exhibit 1. All of the switches in this
topology are HP Provision ASIC switches, and they have established the appropriate adjacencies. In Area 1,
one of the/24 subnets within the/21 range, 10.1.19.0/24, is not used. The network administrator must prevent
unnecessary traffic from entering Area 1 if users attempt to reach an address in the unused range. What can
the administrator do that meets this requirement without disrupting the solution?

View the exhibit.

The OSPF routing table and OSPF settings on an HP 7500 Series routing switch are shown in the exhibit.
Which networks does this switch advertise as summary LSAs in Area 0? (Select two.)

View the exhibit.

Several HP Provision ASIC switches are implementingPIM. Based on the configurations shown in the exhibit,
which switch is included in the dynamic RP set?